Beads Basic - Introduction to Beading



Wire Technique # 2 - Loops

Here are the steps to help you make the S Loop.

S Loop


  S loop 


Put a bead into a eye-pin.

  S loop 



Use a flat nose plier and bend 90 degrees and form a right angle. Leave approximately 1 cm and cut off the excess with the wire cutter.


  S loop 


Using a round nose plier, make a round loop from the end.

 simple S loop 


The finished loop should be as shown. Do not worry as the loop will be more perfect round as you practice more.

Note: Do make sure that the loops are in opposite direction on each side




Return from S Loop to Beading Techniques 

Return from S Loop to Beads Basic Home